XhorseStore.co.uk

Xhorse VVDI Key Tool Max Clone 2015 Nissan Rogue Super Chip

How to use Xhorse VVDI Key Tool Max to clone 2015 Nissan Rogue super chip key? This is a quick demonstration to show transponder setup & programming procedure.

 

Tools Required

Xhorse VVDI Key Tool Max

VVDI Super Chip XT27A

Nissan Original key

Nissan Blank key

Condor XC-009 Key Cutting Machine

Xhorse VVDI Key Tool Max Clone 2015 Nissan Rogue Super Chip

 

Operations

  • Clone Super Chip

Place the original key into Key Tool Max coil, press

Transponder clone >> Read transponder

 

Confirm the transponder is 46 type.

Clone >> Start clone >> 46 transponder clone

 

Ensure the key is centered in coil for good read.

Take out the key and place Super Chip into chip slot as prompted.

 

Copy successfully.

Press “Complete” when finished.

 

  • Cut New Key
  1. Place the programmed XT27A chip into blank key.
  2. Place original key into Condor XC-009 guide clamp.
  3. Place blank key into Condor XC-009 cut clamp.
  4. Check the spacing and tip alignment to cut the key.

 

Cutting completed, go on next step.

 

  • Program New Key
  1. Insert original key into ignition and start it.
  2. Remove original key and insert new key to start when running and all dash lights are off.

 

Vehicle should start normally, which means the new key was cloned, cut and programmed successfully.

 

That’s it!

www.xhorsestore.co.uk

(Visited 27 times, 1 visits today)
Exit mobile version