Hello, I’m here to show how to quickly clone an aftermarket remote with Xhorse VVDI Key Tool Max PRO programmer. This is the new key to be cloned, it’s a Wired Remote comes from Xhorse.
Preparation
As it’s a wired remote, you have to open key shell and take out the circuit board. I usually use a lighter to do it.
- Take out circuit board, don’t put any battery on it.
- Connect the Universal Remote Key board to VVDI Key Tool Max PRO via cable.
Now, let’s start!
Clone Remote
Hold the working key. Go to
Remote clone >> Special clone >> Start clone
Just follow the prompts to operate:
Press Lock button.
Press again Lock button.
Press Unlock button.
Press again Unlock button.
Press Trunk button.
Press again Trunk button.
Press Panic button.
Press again Panic button.
*If verification failed, just try re-acquisition again.
*If the button is not required, press “Skip this button”.
Confirm the frequency: 433.92MHz, 184bps.
Press “Clone”.
Writing data…
Burn success.
Unplug the universal key board to install a battery.
Test the remote to check if it works.
Perfect! All buttons can work.
Put the board back to key shell, that’s it.
